Ethernet Switching
Highlighted
Ethernet Switching

New to Juniper, EX3400 VC stack setup help

‎10-02-2017 08:37 AM

Brand new to Juniper.  Have a very basic setup.  Cisco router, 4 ex3400 that I have setup as a VC.  Just need help getting the VC to communicate out to the cisco router (192.168.1.1).  Everything in the same vlan etc.

1 REPLY 1
Highlighted
Ethernet Switching

Re: New to Juniper, EX3400 VC stack setup help

‎10-02-2017 11:57 PM

Hi,

 

I am assuming that you have configured a 4 member VC using EX3400.

In this case you may need to configure below steps for a basic connectivity.

 

a. Configure same vlan on EX3400-VC :

set vlans test vlan-id <>
set vlans test l3-interface irb.<>

 

b. Configure an IP address on vlan irb :

set interfaces irb unit <>  family inet address <>

 

c. Configure uplink port for that vlan:

set interfaces <> unit 0 family ethernet-switching interfcae-mode trunk

set interfaces <> unit 0 family ethernet-switching vlan members test

 

You may refer below document for details:

https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/bridging-vlans-ex-series...

 

Hope this helps.

-Ajo Thomas

 

Feedback