Ethernet Switching
Ethernet Switching

Steps to configure DHCP relay configuration using Server Groups in EX series switches

‎06-23-2016 10:57 AM
  1. Create the server group name along with IP address

set forwarding-options dhcp-relay server-group <name> ip address

set forwarding-options dhcp-relay server-group <name> ip address

 

 

  1. Setting dhcp relay interfaces group request to new created server group

set forwarding-options dhcp-relay group Clients active-server-group <NAME>

 

 

  1. Applying and using dhcp relay group to applicable vlan interfaces

set forwarding-options dhcp-relay group Clients interface vlan.x

set forwarding-options dhcp-relay group Clients interface vlan.xx

3 REPLIES 3
Ethernet Switching

Re: Steps to configure DHCP relay configuration using Server Groups in EX series switches

‎06-23-2016 03:45 PM

I'm not sure what you question or issue is here.  What are you trying to configure?

Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home
Ethernet Switching

Re: Steps to configure DHCP relay configuration using Server Groups in EX series switches

‎06-23-2016 04:01 PM
nice Smiley Happy
Regards,
A'bed AL-R.
[JNCSP-SEC JNCDA JNCIS-ENT Ingenious Champion|Sec]
https://srxtech.wordpress.com
Ethernet Switching
Solution
Accepted by topic author gumberamit
‎06-24-2016 12:57 PM

Re: Steps to configure DHCP relay configuration using Server Groups in EX series switches

‎06-24-2016 12:36 PM

These are steps that I am following while doing configuration!