Ethernet Switching
Highlighted
Ethernet Switching

port-channel configuration on cisco N7K

‎02-06-2015 06:59 AM

Hi All,

 

I am trying to build a layer 2 port channel between 2 cisco N7K using a breakout cable 40G to 4x10G but it didn't work at all.

 

please check the attached and let me know what is the configuration required to build such a port channel. maybe I missed something during the configuration.

 

also please note that  I am doing configuration like this:

 

interface eth3/4: the 40G interface

channel-group 1 mode active

 

and I put all the 4 x10G interfaces on the second nexus to be on the same channel group, mode, trunk, allowed vlan, ....etc.

 

that's all what I have done. if any special configuration is required, please let me know.

 

note that I tried the same between 2 ASR9K, the 40G interface remains down but the 4x10G interfaces become up.

 

appreciate your valuable support.

 

thanks,

 

Haitham

Attachments

2 REPLIES 2
Highlighted
Ethernet Switching

Re: port-channel configuration on cisco N7K

‎02-06-2015 07:02 AM

Why are you asking Cisco question in Juniper Forum??

Highlighted
Ethernet Switching

Re: port-channel configuration on cisco N7K

‎02-06-2015 08:24 AM
Feedback