right multicast configuration when using a EX4300 as layer2 aggregation switch for many source befor the pim router
I would like check with you guys if I have done the best configuration for following scenario.
I have 10 sources (servers) which are connected to an ex4300 for port aggregation.
The uplink from ex4300 is connected to the pim-router.
In the ex4300 I have only activated igmp-snooping.
In the pim-router I have activated PIM and IGMP.
Every thing work, but I'm not sure it is the right way
Everything is getting a little backward. In most cases, you have layer2 switches after query router against all receivers. When I do show command in the layer2 switch for igmp-snooping, all senders respond to igmp query messages. Can I do a better configuration so the L2 switch knows how to send all multicast traffic to the pim router without sending query message?