Hi Big,
Greetings,
I have gone through all the logs and found below suspicious logs are appearing for SFP of FPC 0 –
When a low power condition is detected on an SFP, a message similar to the following appears in the Syslog:
The bus that the router uses to monitor the SFP and update diagnostic data is called "i2c" or IIC, for an inter-integrated circuit. Conditions sometimes arise that cause the i2c to miss updates. As a result, you might see warnings and alarms regarding low power that subsequently clear. These should not affect traffic in any way.
This issue is seen more often when non-Juniper SFPs are used because different SFP makers handle SFP monitoring in different ways.
Since we are receiving the low power, So I would suggest you to please re-insert or swap out the SFP at the remote end and then check if these logs are still appearing or not.
Please mark "Accepted Solution" if this helps.
Kudos are always appreciated
Thanks
Suraj