IOS to Junos (I2J) Tips
IOS to Junos (I2J) Tips

show bgp routes per neighbour

[ Edited ]
‎03-30-2012 04:42 AM

show ip bgp neighbors 1.2.3.4 advertised-routes

becomes

show route advertising-protocol bgp 1.2.3.4

 

and

 

show ip bgp neighbors 1.2.3.4 received-routes

becomes

show route receive-protocol bgp 1.2.3.4

 

You use these when you want to see what rules you're sending to/receiving from a BGP neighbour.

When I bring up a new BGP peer, I always use "show bgp neighbour 1.2.3.4"

(IOS: show ip bgp neighbour) to see how many routes I'm receiving from my new peer.

 

If I see a difference between Active and Received routes in the output, I use the above

commands to see what I'm receiving from the neighbour - so I can see why some of

the routes are NOT being preferred.

 

1 REPLY 1
IOS to Junos (I2J) Tips

Re: show bgp routes per neighbour

‎04-03-2012 06:44 AM

Hi Hiber.

 

You miss from your cisco config, that if you want to see the received routes, then you have to configure the soft reconfiguration inboud. Im not sure if you need this in junos. I will check later.

 

 

 

 

Br
Alex

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

If you want to say thanks, the word is Kudos!!.

Thx.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

JNCIA-JUNOS, JNCIS-ENT, JNCIS-SP, JNCIP-SP.
CCNA, CCNP, Written CCIE.