Identity & Policy Control - SBR Carrier & SRC
Identity & Policy Control - SBR Carrier & SRC

SRC C2000: after upgrade CLI not connecting

‎11-23-2014 01:37 PM

Hi Guys,

 

I have a little issue on my hands. Not sure if this is the correct board to post this

 

I have a C2000 Juniper, it is running on version 4.0.0R22, as soon as I upgrade it either to 4.1 or 4.2 i get a CLI cant connect.

 

Even if the SRC is on 4.0.0R12 it does the same.

 

I did went into the BASH and tried to started it maunally, by using to following

 

/opt/UMC/cli/etc> cli stop

/opt/UMC/cli/etc> cli start

/opt/UMC/cli/etc> cli status

 

As soon as I use the status commend I get a response by, CLI is running, but it's dead.

 

 

Any assistance will be appriciated.

 

 

Regards

2 REPLIES 2
Highlighted
Identity & Policy Control - SBR Carrier & SRC
Solution
Accepted by topic author luykes
‎08-26-2015 01:27 AM

Re: SRC C2000: after upgrade CLI not connecting

‎11-23-2014 09:26 PM

Hi,

 

SRC 4.0.0 is quite old release, and it is not likely someone remembers what was happening in your situation many years ago. Due to the large gap, usual advice is to fresh install target release (like 4.5.0) and mirgate configuration.

 

Your current issue is likely to be a JDB problem, but I suggest adressing your final goal instead to avoid repeative trouble-shooting.

 

Regards,

/Charlie

 

Identity & Policy Control - SBR Carrier & SRC

Re: SRC C2000: after upgrade CLI not connecting

‎11-24-2014 01:47 PM

Thank you Charlie.

 

I have fresh reload the SRC. Created a bootable USB.

 

http://www.juniper.net/techpubs/en_US/src4.5/topics/task/configuration/src-system-software-c-series-...

 

Also thank to Dave S from Juniper for assiting as well.