Hello,
Can I display statistics and diagnostics on STM-4 interface after creating no-concatenate port?
I get:
> show interfaces so-3/2/0
error: device so-3/2/0 not found
{master}
> show interfaces diagnostics optics so-3/2/0
{master} >
On the other hand I can see, only, on the VC4s:
> show interfaces so-3/2/0:3
Physical interface: so-3/2/0:3, Enabled, Physical link is Up
Interface index: 184, SNMP ifIndex: 208
Description:
Link-level type: PPP, MTU: 4474, Clocking: External, SDH mode, Speed: OC3, Loopback: None, FCS: 32,
Payload scrambler: Enabled
Device flags : Present Running
Interface flags: Point-To-Point SNMP-Traps Internal: 0x4000
Link flags : No-Keepalives
LCP state: Opened
NCP state: inet: Opened, inet6: Not-configured, iso: Not-configured, mpls: Not-configured
CHAP state: Closed
PAP state: Closed
CoS queues : 8 supported, 8 maximum usable queues
Last flapped : 2009-02-25 09:38:24 IST (1d 03:48 ago)
Input rate : 99382528 bps (17730 pps)
Output rate : 504 bps (0 pps)
SDH alarms : None
SDH defects : None
Logical interface so-3/2/0:3.0 (Index 88) (SNMP ifIndex 209)
Flags: Point-To-Point SNMP-Traps 0x4000 Encapsulation: PPP
Protocol inet, MTU: 4470
Flags: Sample-input
Addresses, Flags: Is-Preferred Is-Primary
Destination: , Local: , Broadcast:
Thanks,
ZivMessage Edited by ziv on 02-26-2009 03:34 AM