Hello Rahul,
Rate 1024 is what I get from our previous router and it was working fine with that value. So you mean if I lower the rate value, more flow would be sent to collector, is that what you suggested?
Here is the output from some show commands
> show services accounting status inline-jflow fpc-slot 0
Status information
FPC Slot: 0
IPV4 export format: Version9, IPV6 export format: Not set
VPLS export format: Not set, MPLS export format: Not set
IPv4 Route Record Count: 725062, IPv6 Route Record Count: 0, MPLS Route Record Count: 0
Route Record Count: 725062, AS Record Count: 218394
Route-Records Set: Yes, Config Set: Yes
Service Status: PFE-0: Steady
Using Extended Flow Memory?: PFE-0: No
Flex Flow Sizing ENABLED?: PFE-0: No
IPv4 MAX FLOW Count: 1831940, IPv6 MAX FLOW Count: 1024
VPLS MAX FLOW Count: 1024, MPLS MAX FLOW Count: 1024
> show services accounting flow inline-jflow fpc-slot 0
Flow information
FPC Slot: 0
Flow Packets: 256950401, Flow Bytes: 189918607240
Active Flows: 36406, Total Flows: 219539779
Flows Exported: 479584424, Flow Packets Exported: 96384248
Flows Inactive Timed Out: 105479689, Flows Active Timed Out: 113646563
Total Flow Insert Count: 105893216
IPv4 Flows:
IPv4 Flow Packets: 256950401, IPv4 Flow Bytes: 189918607240
IPv4 Active Flows: 36406, IPv4 Total Flows: 219539779
IPv4 Flows Exported: 479584424, IPv4 Flow Packets exported: 96384248
IPv4 Flows Inactive Timed Out: 105479689, IPv4 Flows Active Timed Out: 113646563
IPv4 Flow Insert Count: 105893216
> show services accounting errors inline-jflow fpc-slot 0
Error information
FPC Slot: 0
Flow Creation Failures: 1891898
Route Record Lookup Failures: 344604, AS Lookup Failures: 344604
Export Packet Failures: 1024
Memory Overload: No, Memory Alloc Fail Count: 0
IPv4:
IPv4 Flow Creation Failures: 1891898
IPv4 Route Record Lookup Failures: 344604, IPv4 AS Lookup Failures: 344604
IPv4 Export Packet Failures: 1024
Is there any missing point you could advise?
Thanks and regards,