Junos
Highlighted
Junos

MPC 3D 16x 10GE rebooted

a week ago

Hello guys

Juniper MX960 version 18.4R3

I had a flap of a whole MPC 3D 16x 10GE. 

The router is terminating DHCP clients ~25k. ~45Gbit traffic go thru.

This is the first time that happened 

I have attached logs

I would be very appreciated of any advice

Thanks

Attachments

2 REPLIES 2
Highlighted
Junos

Re: MPC 3D 16x 10GE rebooted

[ Edited ]
a week ago

Hi, these logs matched to one of internal PR , you can open case to JTAC and they will recommend you sw version where this PR fixed

 

P.S. MPC 3D 16x 10GE is not officially supported for Subscriber Management 



===================================================
If this solves your problem, please mark this post as "Accepted Solution".
If you think that my answer was helpful, please spend some Kudos.
Highlighted
Junos

Re: MPC 3D 16x 10GE rebooted

a week ago

 

Could you tell me the content of the PR and recommended version?

I do not have access to JTAC

 

I  would be very pleased

 

Feedback