Junos OS

From the output below how can I tell if OSPF traffic engineering is enabled? Thanks in advanced.

user@router> show ospf database

OSPF database, Area 0.0.0.0

Type ID Adv Rtr Seq Age Opt Cksum Len

Router 5.5.5.5 5.5.5.5 0x80000007 471 0x22 0x180 60

Router *66.129.12.2 66.129.12.2 0x80000010 470 0x22 0xeb7 48

Network *66.129.12.2 66.129.12.2 0x80000006 470 0x22 0x248 32

Network *172.16.12.110 66.129.12.2 0x80000009 470 0x22 0xcb7 32

OpaqArea 1.0.0.1 5.5.5.5 0x80000003 471 0x22 0x3cc 28

Hi,

If you are just looking for a command to verify if OSPF has traffic engineering enabled or not, you can probably use "show ospf overview"

lab> show ospf overview
Instance: master
  Router ID: 10.85.0.12
  Route table index: 0
  LSA refresh time: 50 minutes
  Traffic engineering
  Area: 0.0.0.0
    Stub type: Not Stub
    Authentication Type: None
    Area border routers: 0, AS boundary routers: 0
    Neighbors
      Up (in full state): 2
  Topology: default (ID 0)
    Prefix export count: 0
    Full SPF runs: 6
    SPF delay: 0.200000 sec, SPF holddown: 5 sec, SPF rapid runs: 3
    Backup SPF: Not Needed

lab> show configuration protocols ospf   
traffic-engineering;

Hope this helps

--------------------------------------------------------------------------------------------------------
If this post was helpful, please mark this post as an "Accepted Solution".
Kudos are always appreciated!
--------------------------------------------------------------------------------------------------------

My 2 cents..

if you see OpaqArea  in ospf database, that means TE is enabled

HTH