Junos
Highlighted
Junos

Replacing a EX2300-24P switch that is a member of a 2 switch virtual chasis

‎02-14-2019 03:06 PM

Hi there

I am about to replace a Juniper EX2300-24P switch that is a member of a 2 switch virtual chasis stack.
Is there anything I need to do before installing this? Or does the master controller auto configures the ports to what the defective EX2300-24P had? Please advise Smiley Happy

 

1 REPLY 1
Junos

Re: Replacing a EX2300-24P switch that is a member of a 2 switch virtual chasis

‎02-14-2019 03:17 PM

Before installation you need to put the same version of Junos on the new switch that the master in the stack is already running.

 

Make sure the switch is at factory default configuration

 

Attach the VCP cable and then power up the switch.

 

Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home