The router only boots to loader tried installing with tftp but looks like disk space is an issue. How to clean the disk in loader mode?
thks
loader> install tftp://10.157.70.171/junos-srxsme-15.1X49-D150.2-domestic.tgz
Target device selected for installation: internal media
/kernel data=0xba1ec0+0x152c60 syms=[0x4+0xa0a30+0x4+0xf0706]
Kernel entry at 0x801000c0 ...
init regular console
Primary ICache: Sets 16 Size 128 Asso 39
Primary DCache: Sets 8 Size 128 Asso 32
Secondary DCache: Sets 1024 Size 128 Asso 4
CIU_FUSE 0x3/0x3
GDB: debug ports: uart
GDB: current port: uart
KDB: debugger backends: ddb gdb
KDB: current backend: ddb
kld_map_v: 0x8ff80000, kld_map_p: 0x0
Running in PARTITIONED TLB MODE
Copyright (c) 1996-2018, Juniper Networks, Inc.
All rights reserved.
Copyright (c) 1992-2007 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
JUNOS 15.1X49-D150.2 #0: 2018-09-19 17:44:55 UTC
builder@monarth.juniper.net:/volume/build/junos/15.1/service/15.1X49-D150.2/obj/octeon/junos/bsd/kernels/JSRXNLE/kernel
can't re-use a leaf (perf_mon)!
can't re-use a leaf (threshold)!
can't re-use a leaf (debug)!
JUNOS 15.1X49-D150.2 #0: 2018-09-19 17:44:55 UTC
builder@monarth.juniper.net:/volume/build/junos/15.1/service/15.1X49-D150.2/obj/octeon/junos/bsd/kernels/JSRXNLE/kernel
real memory = 4294967296 (4194304K bytes)
avail memory = 3091644416 (2948MB)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
Security policy loaded: JUNOS MAC/runasnonroot (mac_runasnonroot)
Security policy loaded: Junos MAC/veriexec (mac_veriexec)
Security policy loaded: JUNOS MAC/pcap (mac_pcap)
MAC/veriexec fingerprint module loaded: SHA1
MAC/veriexec fingerprint module loaded: SHA256
netisr_init: !debug_mpsafenet, forcing maxthreads from 2 to 1
cpu0 on motherboard
: CAVIUM's OCTEON 70XX/71XX CPU Rev. 0.2 with no FPU implemented
L1 Cache: I size 78kb(128 line), D size 32kb(128 line), thirty two way.
L2 Cache: Size 512kb, 4 way
obio0 on motherboard
uart0: <Octeon-16550 channel 0> on obio0
uart0: console (9600,n,8,1)
twsi0 on obio0
set clock 0x31
xhci0: <Cavium Octeon 7xxx xHCI Host Driver> on obio0
usb0: <USB bus for xHCI Controller> on xhci0
usb0: USB revision 3.0
uhub0: vendor 0x0000 XHCI root hub, class 9/0, rev 3.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
xhci1: <Cavium Octeon 7xxx xHCI Host Driver> on obio0
usb1: <USB bus for xHCI Controller> on xhci1
usb1: USB revision 3.0
uhub1: vendor 0x0000 XHCI root hub, class 9/0, rev 3.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
cpld0 on obio0
pcib0: <Cavium on-chip PCIe HOST bridge> on obio0
Disabling Octeon big bar support
pcib0: Initialized controller
pci0: <PCI bus> on pcib0
pci0: <network, ethernet> at device 0.0 (no driver attached)
pci0: <network, ethernet> at device 0.1 (no driver attached)
gblmem0 on obio0
octpkt0: <Octeon RGMII> on obio0
cfi0: <Macronix MX25L64 - 8MB> on obio0
cfi1: <Macronix MX25L64 - 8MB> on obio0
umass0: Silicon Motion,Inc. SM3255AA MEMORY BAR, rev 2.00/1.00, addr 2
umass1: Generic Mass Storage, rev 2.00/1.00, addr 2
octpkt_attach: Initializing octpkt0 interface
Timecounter "mips" frequency 1200000000 Hz quality 0
Registered AMT tunnel Encap with UDP Tunnel!
Loading Redundant LT driver
###PCB Group initialized for udppcbgroup
###PCB Group initialized for tcppcbgroup
md0: Preloaded image </isofs-install-srxsme> 20002816 bytes at 0x80f85c60
da1 at umass-sim1 bus 1 target 0 lun 0
da1: <Generic Flash Disk 8.07> Removable Direct Access SCSI-4 device
da1: 40.000MB/s transfers
da1: 15200MB (31129600 512 byte sectors: 255H 63S/T 1937C)
Kernel thread "wkupdaemon" (pid 54) exited prematurely.
da0 at umass-sim0 bus 0 target 0 lun 0
da0: < USB MEMORY BAR 1000> Removable Direct Access SCSI-0 device
da0: 40.000MB/s transfers
da0: Attempt to query device size failed: NOT READY, Medium not present
(da0:umass-sim0:0:0:0): READ CAPACITY. CDB: 25 0 0 0 0 0 0 0 0 0
(da0:umass-sim0:0:0:0): CAM Status: SCSI Status Error
(da0:umass-sim0:0:0:0): SCSI Status: Check Condition
(da0:umass-sim0:0:0:0): NOT READY asc:3a,0
(da0:umass-sim0:0:0:0): Medium not present
(da0:umass-sim0:0:0:0): Unretryable error
Opened disk da0 -> 6
(da0:umass-sim0:0:0:0): READ CAPACITY. CDB: 25 0 0 0 0 0 0 0 0 0
(da0:umass-sim0:0:0:0): CAM Status: SCSI Status Error
(da0:umass-sim0:0:0:0): SCSI Status: Check Condition
(da0:umass-sim0:0:0:0): NOT READY asc:3a,0
(da0:umass-sim0:0:0:0): Medium not present
(da0:umass-sim0:0:0:0): Unretryable error
Opened disk da0 -> 6
Trying to mount root from cd9660:/dev/md0
WARNING: preposterous time in file system
WARNING: clock 11563 days greater than file system time
tty: not found
Starting JUNOS installation:
Source Package: net0:/junos-srxsme-15.1X49-D150.2-domestic.tgz
Target Media : internal
Product : srx300
add default: gateway 10.157.70.171
PING 10.157.70.171 (10.157.70.171): 56 data bytes
64 bytes from 10.157.70.171: icmp_seq=0 ttl=128 time=1.051 ms
--- 10.157.70.171 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
round-trip min/avg/max/stddev = 1.051/1.051/1.051/0.000 ms
Computing slice and partition sizes for /dev/da0 ...
awk: division by zero
input record number 1, file
source line number 3
The target media /dev/da0 (0 bytes) is too small.
The installation cannot proceed
ERROR: Target media is too small
Waiting (max 60 seconds) for system process `vnlru' to stop...done
Waiting (max 60 seconds) for system process `vnlru_mem' to stop...done
Waiting (max 60 seconds) for system process `bufdaemon' to stop...done
Waiting (max 60 seconds) for system process `syncer' to stop...
Syncing disks, vnodes remaining...1 0 done