Did anybody faced issue with VCF not allowing to add more than 16 leaf ?
I have VCF setup with all QFX5100 running junos 14.1X53-D35.3
right now I am having 2 Spine and 9 leaf.
Now I was adding 7more leaf to it and it got very angry and caused outage.
It is not allowing me to add more that 16 (total Nodes including spines) But as per documentation I can have total 32 nodes.
Anybody faced the same issue ? any suggestion on what I am doing wrong here ? any special config required ?
Thanks in advance
Are you using pre-provisioned mode, or auto-provisioned?
Are you running the standard image or the Automation image?
There doesn't seem to be any documentation to suggest that you need more Spines for more than 16 leaf nodes (even in the QFX5100 Series Book), so it Should Just Work™