Junos
Junos

error Ex4200: rend_dlinit

04.29.11   |  
‎04-29-2011 01:26 AM

Dear all,

 

I've had following error on a EX4200-24t:.  (It is not a member of a Virtual Chassis.)

 

rend_dlinit: not a proper library: /usr/lib/render//libvccpd-render.so: Cannot open "/usr/lib/render
//libvccpd-render.so"
{linecard:0}

 

There was no routing possible (It's normal because the switch got in linecard-mode) How this is possible, I don't know. Software version is 10.3

 

I've recoverd the switch by reinstalling the software through an USB-stick.  Does anyone know why the switch gave me this problem???

 

Thanks in advance!

 

Best regards,

 

Lars Aerts

 

4 REPLIES
Junos

Re: error Ex4200: rend_dlinit

04.29.11   |  
‎04-29-2011 03:07 AM

Hi Lars Aerts,

 

Requirements:  You need, Junos OS Release 11.1 or later to have an RVI to route traffic between two VLANs on the same switch.

 

 

Thanks,

 

Jay

Highlighted
Junos

Re: error Ex4200: rend_dlinit

04.30.11   |  
‎04-30-2011 01:41 AM

I don't get your answer I think...

 

Do you mean the following:

When you have the following thing configured on the ex4200.  It won't route that traffic when you have soft-version 10.3???

 

Set interfaces vlan unit 100 family inet address 192.168.0.1/24

Set interfaces vlan unit 200 family inet address 192.168.1.1/24

 

Set vlans test vlan-id 100

set vlans test interface ge-0/0/0

 

Set vlans test1 vlan-id 200

set vlans test interface ge-0/0/1

 

 

Junos

Re: error Ex4200: rend_dlinit

04.30.11   |  
‎04-30-2011 05:34 AM

RVI is a basic feature of the EX switch line since the initial release.  From what you show above it appears that the Junos installation is corrupt.

 

Maybe the recover from a failed software installation procedure will help.

 

http://kb.juniper.net/InfoCenter/index?page=content&id=KB10914

 

Be sure to save out a copy of your current configuration in case this gets lost in the processes.

 

Rescue config will put a copy on the device you can pull from.

 

system configuration rescue save

 

KB12022 shows how to put a copy to a usb disk

 

http://kb.juniper.net/InfoCenter/index?page=content&id=KB12022

Steve Puluka BSEET
Juniper Ambassador
Senior IP Engineer - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
JNCIA-Junos JNCIS-SEC JNCIP-SEC JNCSP-SEC
JNCIS-FWV
JNCDA JNCDS-DC JNCDS-SEC
JNCIS-SP
ACE PanOS 6 ACE PanOS 7
http://puluka.com/home
Junos
Solution
Accepted by topic author LA
‎08-26-2015 01:27 AM

Re: error Ex4200: rend_dlinit

05.02.11   |  
‎05-02-2011 05:41 AM

Thanks for the information