Junos
Highlighted
Junos

show rsvp interface info with SNMP

[ Edited ]
‎06-18-2014 02:13 PM

Hello,

 

my first post, here because there is no snmp section on the forum :

 

my question :

 

I want to make a nagios check that make a warning if reserved bandwith is more than 50% of available bandwith.

 

on cli interface i can type the following command :

 

show rsvp interfaces

 

and got this (just an exemple).

 

RSVP interface: 4 active 
                  Active Subscr- Static      Available   Reserved   Highwater 
Interface   State resv   iption  BW          BW          BW         mark 
fe-0/0/0.0  Up         2   100%  155.52Mbps  155.52Mbps  50Mbps     0bps 
fe-0/0/1.0  Up         0   100%  155.52Mbps  155.52Mbps  0bps       0bps 
fe-1/0/1.0  Up         0   100%  155.52Mbps  155.52Mbps  0bps       0bps 

I'm searching for the oid that can permit to retreive this informations.

 

before asking here I try some lots of snmpwalk, look at lot of mib (ex http

://www.juniper.net/techpubs/en_US/junos11.4/topics/reference/mibs/mib-jnx-rsvp.txt ) but without success

 

equipement : mx80 junos 11.4

 

regards

 

Nicolas

 

1 REPLY 1
Highlighted
Junos

Re: show rsvp interface info with SNMP

‎06-30-2014 12:40 AM

hi,

 

Can someone tell me if there is an OID that contain this informations ?

 

if not why (because of my junos version ?, router hardware ? ) ?

 

what can i do to get this information ? ( I don't want to make a ssh connection and retreive the output of "show rsvp interfaces")

 

regards

Feedback