Management
Highlighted
Management

NSM 2007 2r2 installation

‎08-01-2011 04:23 AM

Hello,

I am installing an NSM 2r2 as a standby member (the gui and dev server are on the same device) of a cluster (system is a Redhat3up9)
I follow the install guide from Juniper, but I have a problem with the GuiSvr.
When I do: /etc/init.d/haSvr start
I check the state of the guiSvr, I have this result:
guiSvrManager ..............................................ON
guiSvrMasterController ....................................ON
guiSvrDirectiveHandler.pid exists but guiSevDirectiveHandler is off
guiSvrStatusMonitor ......................................ON


After few minutes, when I do a new check on guiSvr, all the indicators are "off" ...
Do you have any Idea about this problem ?

Thank you in advance