Routing
Highlighted
Routing

Can a MX80 perform NAPT?

‎01-02-2014 09:21 AM

I am trying to configure a MX80 to perform NAT from multiple inside addresses, using a single Public IP address. I have done this with ease on SRX devices. It appears that all documentation I can find suggests only basic 1:1 static NAT can be performed. Can anyone tell me if it is possible to perform network address port translation? If so, could you provide an example config?

 

 

JNCIE-ENT #552, JNCSP-ENT, JNCIP-SEC, JNCIP-SP, JNCIP-DC, JNCDS-DC, JNCDS-SEC, JNCDS-SP, CCNP, CCDA
2 REPLIES 2
Highlighted
Routing
Solution
Accepted by topic author Regalis
‎08-26-2015 01:27 AM

Re: Can a MX80 perform NAPT?

‎01-02-2014 09:40 AM

Hi

 

You can't do this type of NAT (with port translation) on MX80 without additional

equipment. Juniper now offers a multiserivces MIC that can do it

 

http://www.juniper.net/techpubs/en_US/junos13.2/topics/concept/ms-mic-and-mpc-overview.html

 

But you will need to purchase this additional module (to be installed in the rear slot

of MX80, AFAIK). Also note that NAT config will be significantly different compared

to SRX one.

Best Regards,
PK

Juniper Ambassador, Juniper Networks Certified Instructor,
JNCIE-SEC #98, JNCIE-ENT #393, JNCIE-SP #2253
Twitter: @JuniperTrain
GitHub: https://github.com/pklimai
[Juniper Authorized Education & Support in Russia]
Routing

Re: Can a MX80 perform NAPT?

‎01-03-2014 04:34 AM

Thanks PK!

 

I have looked into this on the Juniper Website and MX data sheet and it confrims what you are saying.

JNCIE-ENT #552, JNCSP-ENT, JNCIP-SEC, JNCIP-SP, JNCIP-DC, JNCDS-DC, JNCDS-SEC, JNCDS-SP, CCNP, CCDA