On cisco as per below output we can get the maximum routes for the chassis. But how in juniper? Do we have that command out like that?
show cef platform resource location 0/0/CPU0Used Entries: 847166 Max Entries: 4194304
Thanks an appreciate any feedback
Go to Solution.
show pfe route
Will have this information on some platforms.
I think that command not show the maximum route that box can support.
Thanks and appreciate your feedback
The number for free routes only displays on some platforms not all showing the total table available per route type.
This is present on QFX, ex4600 and OCX platforms.
In JunOS the command is "show pfe routes summary". Normally you'll have 2 line controller; so you'll see max routes for FPC0 and FPC1
There is no exect limit on MX platform bacause it is depends on network topology/frr/filters/knobs in config and some other options .
Better to monitor pfe resources, for example with this command
show system resource-monitor fpc
show pfe route summary
This command only shows you number of installed routes per table but not how many can be installed,
© 1999 - 2019 Juniper Networks, Inc.
All rights reserved