Hi, I've been at this for a few days now and I can't get to the bottom of it. I'm trying to configure filter based forwarding and redundancy on a srx210H cluster.
reth2 WAN Dedicated BW
reth3 WAN Shared BW
reth4 WAN Backup
What I'm trying to do is route trafic with destination ports 5060 8200 1853 49104-65534 3478 22 80 through reth2 and the rest through reth3 I managed to do this but the problem is that if reth2 is down, traffic won't get redirected to reth3, being the next qualified hop. I tried setining it up with an rpm probe and ip monitoring but it didn't work.
reth4 needs to be backup in case reth2 and reth3 are down. Anyone have any ideeas?
Any info would be much appreciated. Please see my config below:
I'm not sure I follow your configuration. But it looks like your filter is such that all LAN traffic is going to use the dedicated for the selected ports and the shared for everything else. So there does not seem to be any way any traffic will every leave the filter.
typically I see these filters steer the specific traffic then end with a term just accept which then allows the rest of the traffic to fall out of the filter and follow the normal forwarding rules from there.
Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP) http://puluka.com/home
Thank you for your reply. I ended the filter with the Shared term and seems that traffic gets forwarded the normal route. The only problem that I have now is that if the Dedicated WAN is down, traffic with destination port 5060 8200 1853 49104-65534 3478 22 80 gets dropped. Anthing else works fine. Is there a way arround this?