Routing
Highlighted
Routing

Lag interface question on MX104

3 weeks ago

I am reaching out to support for an answer but thought one of you or your compadres might know.  Does the MX104 allow me to LAG 10G interfaces between the on-board and the 10G card in the slot?  Given the configuration below could I take xe-0/0/0 and swap it’s configuration with xe-2/0/3 to split the LAG between a built-in 10G port and a 10G port on the card?

 

I have two dual-port 10G cards in the system.  I also have the built-in ports.  The LAG is split between the two cards but I am wondering if I can split between the built-in and one of the cards.

 

interfaces {

    xe-0/0/0 {

        description "Member BGP group RTC-VTX Raymondville";

        unit 0 {

            family inet {

                filter {

                    input-list Protect_RE;

                }

                address x.x.x.x/30;

            }

        }

    }

    xe-0/1/0 {

        description "LAG AE1 to CORE-SW AE0";

        gigether-options {

            802.3ad ae1;

        }

    }

    xe-0/2/0 {

        description "Member BGP group RTC-VTX Falfurrias";

        unit 0 {

            family inet {

                filter {

                    input-list Protect_RE;

                }

                address x.x.x.x/30;

            }

        }

    }

    xe-0/3/0 {

        description "LAG AE1 to CORE-SW AE0";

        gigether-options {

            802.3ad ae1;

        }

    }

   

    inactive: xe-2/0/0 {

        description "10Gig link to Procera Internal";

        enable;

        vlan-tagging;

        unit 250 {

            vlan-id 250;

            family inet {

                address 10.250.250.1/30;

            }

        }

        unit 251 {

            vlan-id 251;

            family inet {

                address 10.250.251.1/30;

            }

        }

    }

    inactive: xe-2/0/1 {

        description "10Gig link to Procera External";

        enable;

        vlan-tagging;

        unit 250 {

            vlan-id 250;

            family inet {

                address 10.250.250.2/30;

            }

        }

        unit 251 {

            vlan-id 251;

            family inet {

                address 10.250.251.2/30;

            }

        }

    }

    xe-2/0/2 {

        description "10Gig LAG AE2 to RVRA E7-1 LAG1";

        gigether-options {

            802.3ad ae2;

        }

    }

    xe-2/0/3 {

        description "10Gig LAG AE2 to RVRA E7-1 LAG1";

        gigether-options {

            802.3ad ae2;

        }

 

1 REPLY 1
Highlighted
Routing

Re: Lag interface question on MX104

3 weeks ago

hi, yes, you can use any 10gb ports for lag without any limitation



===================================================
If this solves your problem, please mark this post as "Accepted Solution".
If you think that my answer was helpful, please spend some Kudos.
Feedback