Routing
Highlighted
Routing

PPPOE client

05.28.11   |  
‎05-28-2011 01:32 AM

Dear, Please anyone help me to configure our Netscreen 50 as PPPoE client to connect to the internet. Presently i have a small router connecting to the internet and i want to replace with Netscreen 50.

 

I configured Ethernet 1 ---> trust---->NAT----> 10.0.0.202/32

                       Ethernet 3----> Untrust---> obtain ip through PPPOE

 

PPPOE settings are configured with username and password

 

When i say connect it is trying to intializing and then closing and the error i get is " PPPOE connection failed to establish a session, Timeout PADI"

 

Please anyone help.

 

 

 

Regards

 

Abdul Rahuman.M

1 REPLY
Routing

Re: PPPOE client

05.28.11   |  
‎05-28-2011 06:55 AM

Is the dsl modem you are connecting to on ethernet 3 set into bridge mode?

 

I've seen this type of error when the modem is not fully bridged to the dsl network.

Steve Puluka BSEET
Juniper Ambassador
Senior IP Engineer - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
JNCIA-Junos JNCIS-SEC JNCIP-SEC JNCSP-SEC
JNCIS-FWV
JNCDA JNCDS-DC JNCDS-SEC
JNCIS-SP
ACE PanOS 6 ACE PanOS 7
http://puluka.com/home