Hi,
I am trying to configure VPLS pseudowires with dynamic profiles as explained in the following Juniper guide:
http://www.juniper.net/techpubs/en_US/junos12.1/information-products/topic-collections/nce/vpls-dynamic-profile-configuring/vpls-dynamic-profile-configuring.pdf
My issue is that I don't have the keyword access-profile.
# set routing-instances VS protocols vpls neighbor 10.3.0.2 ?
Possible completions:
<[Enter]> Execute this command
+ apply-groups Groups from which to inherit configuration data
+ apply-groups-except Don't inherit configuration data from these groups
> backup-neighbor Configuration of redundant l2circuit
community Community associated with this neighbor
connection-protection End-2-end protection via OAM failure detection
encapsulation-type Encapsulation type for VPN
ignore-encapsulation-mismatch Allow different encapsulation types on local and remote end
> oam OAM Configuration for VPN
pseudowire-status-tlv Send pseudowire status TLV
psn-tunnel-endpoint Endpoint of the transport tunnel on the remote PE
revert-time Enable pseudowire redundancy reversion (seconds) (0..600 seconds)
> static Configuration of static vpls
switchover-delay Pseudowire switchover delay (0..180000 milliseconds)
| Pipe through a command
Does anybody here knows some restriction which might prevent me from using that keyword?
My test platform:
Model: mx960
Junos: 13.3R1.8