Hi All,
I am trying to test multicast setup over an MX480 router. i have both reciever and source connected to 2 interfaces of the same MX. this is the physical setup
Source...>EX2300.....>>Brocade_switch---->ge-1/0/0/20(MX)ge-1/1/9.20--->EX2200----Receiver
MX setup
re0# show protocols pim
interface ge-1/0/0.20 {
mode dense;
}
re0# show protocols igmp
interface ge-1/1/9.20;
re0# run show igmp group 238.5.5.1 detail
Interface: ge-1/1/9.20, Groups: 2
Group: 238.5.5.1
Group mode: Exclude
Source: 0.0.0.0
Source timeout: 0
Last reported by: 10.2.2.2
Group timeout: 228 Type: Dynamic
Output interface: ge-1/1/9.20
..............................................................................................
-re0# run show multicast route group 238.5.5.1
Instance: master Family: INET
Group: 238.5.5.1
Source: 10.5.5.2/32
Upstream interface: ge-1/1/7.20
All switches have IGMP-SNOOP disabled and i am assuming they will flood the muliticast frame .
what could i be doing wromg.. with this setup, i cant stream from the reciever..
anything i need to allow through the RE-PROTECT Lo0 filter ??