Routing

Hi,

When I try to use an entire ethernet port (m7i) for a l2vpn circuit, the session will never goes up.

It says that no hardware is present on the CE side.

Should it be possible to use entire port?

The hardware guide has only reference to vlan encapsulation.

 

etxnreg@junm7iASP-a# show interfaces
fe-0/0/2 {
    encapsulation ethernet-ccc;

 

etxnreg@junm7iASP-a# show protocols l2circuit
neighbor 10.100.5.1 {
    interface fe-0/0/2.0 {
        virtual-circuit-id 1001;
    }
}

 

 

etxnreg@junm7iASP-a# run show l2circuit connections   
Layer-2 Circuit Connections:

Legend for connection status (St)  
EI -- encapsulation invalid      NP -- interface h/w not present  
MM -- mtu mismatch               Dn -- down                      
EM -- encapsulation mismatch     VC-Dn -- Virtual circuit Down   
CM -- control-word mismatch      Up -- operational               
VM -- vlan id mismatch           CF -- Call admission control failure
OL -- no outgoing label          XX -- unknown
NC -- intf encaps not CCC/TCC
CB -- rcvd cell-bundle size bad

Legend for interface status 
Up -- operational           
Dn -- down                  
Neighbor: 10.100.5.1
    Interface                 Type  St     Time last up          # Up trans
    fe-0/0/2.0(vc 1001)       rmt   NP  

[edit]
etxnreg@junm7iASP-a#

 

 

 

 

etxnreg@junm7iASP-a# show interfaces fe-0/0/2 { encapsulation ethernet-ccc; should be like below: etxnreg@junm7iASP-a# show interfaces fe-0/0/2 { encapsulation ethernet-ccc; unit 0 { family ccc; }

Hi mate,

 

You just saved my life 🙂

 

Thanks