Hello guys,
i'm a beginner in juniper (screenOS and Junos) and i'm now converting a screenOS config to junos 11.4 config (cluster).
in the screenOS the ethernet0/0 has an ip address and contains some vlan:
set interface ethernet0/0 ip 192.168.1.4/24
set interface ethernet0/0 nat
set interface ethernet0/0.2 ip 10.87.32.4/29
set interface ethernet0/0.2 route
set interface ethernet0/0.3 ip 10.88.30.1/29
set interface ethernet0/0.3 route
i want to do the same in junos, when i add the vlans it's ok but when i want to attribute an ip address to the reth0 the junos shows an error:
(i tested set interfaces reth0 unit 0 family inet @ip and
set interfaces reth0 unit 0 vlan-id 0
set interfaces reth0 unit 0 family iner address @ip)
below the rth0 config:
set interfaces reth0 vlan-tagging
set interfaces reth0 redundant-ether-options redundancy-group 1
set interfaces reth0 unit 20 vlan-id 20
set interfaces reth0 unit 20 family inet address 10.104.40.33/27
set interfaces reth0 unit 30 vlan-id 30
set interfaces reth0 unit 30 family inet address 10.104.40.94/27
set interfaces reth0 unit 134 vlan-id 134
set interfaces reth0 unit 134 family inet address 10.87.134.86/29
Thank you for your support,
Kind Regards.