SRX Services Gateway
SRX Services Gateway

Configure SRX as NTP Server.

05.23.12   |  
‎05-23-2012 12:32 AM
Hi All, May I know whether SRX can setup as NTP Server or not ? If Yes can please share the step ? Thanks,
7 REPLIES
SRX Services Gateway

Re: Configure SRX as NTP Server.

05.23.12   |  
‎05-23-2012 01:37 AM
Hi,

SRX can be set up as a NTPServer but only when SRX is getting the timing info from another NTPServer .i,e it is acting as a client . Other than this pre-requisite , there is no other configuration required .

For NTP client side configuration, please check http://kb.juniper.net/KB15756

hope this helps!
Regards,
Pradeep JNCIE-SEC
SRX Services Gateway

Re: Configure SRX as NTP Server.

05.23.12   |  
‎05-23-2012 07:19 AM

Hi Pradeep,

 

After I configure the SRX as the NTP client from other NTP server, is the SRX will be automatic become the NTP server form my LAN equipment ?

 

Thanks for the reply.

SRX Services Gateway

Re: Configure SRX as NTP Server.

05.23.12   |  
‎05-23-2012 06:45 PM
Yes, you just need to configure your Lan clients to point towards SRX for fetching timing information.
Regards,
Pradeep JNCIE-SEC
SRX Services Gateway

Re: Configure SRX as NTP Server.

05.23.12   |  
‎05-23-2012 08:51 PM
Hi Pradeep, Thanks for your support. I will try.
SRX Services Gateway

Re: Configure SRX as NTP Server.

07.31.15   |  
‎07-31-2015 11:50 PM

Did you actually make this work ?

SRX Services Gateway

Re: Configure SRX as NTP Server.

08.04.15   |  
‎08-04-2015 09:38 PM

 

Works OK for me. You will need to set host-inbound-traffic system-services ntp for the interface or zone which is facing the client system though.

 

 

SRX Services Gateway

Re: Configure SRX as NTP Server.

09.01.16   |  
‎09-01-2016 02:19 AM
I have only ping, snmp, netconf on this interface.
But NTP service is working fine