SRX Services Gateway
SRX Services Gateway

Data Center SRX and VRRP support

01.20.12   |  
‎01-20-2012 08:02 AM

Hi there, 

I've searched within documentation and found that on Branch series SRX gateways, there is no VRRP support in chassis cluster mode. Does similar restriction applied to the data center series?

I want to use VRRP between 2 chassis cluster. ( SRX model is :  SRX3600)

 

Thanks in advance

Misha

Best Regards,
Misha
2 REPLIES
SRX Services Gateway

Re: Data Center SRX and VRRP support

01.20.12   |  
‎01-20-2012 09:03 AM


Hi Misha,

 

VRRP on SRX Chassis Cluster is not supported at all. This is because of the fact that both does the same job. The only difference is that VRRP is stateless  and Chassis cluster provides stateful failover. You can choose either one of them. Refer kb http://kb.juniper.net/InfoCenter/index?page=content&id=KB12881&smlogin=true


Hope this helps.


Regards,

Visitor

-------------------------------------------------------------------------------------------------------

If this post was helpful, please mark this post as an "Accepted Solution".Kudos are always appreciated!

SRX Services Gateway

Re: Data Center SRX and VRRP support

01.13.15   |  
‎01-13-2015 06:59 AM

Dear,

 

the link you are providing is for the using VRRP and JSRP on the same physical interface,

 

What about using another interface ?

 

Thanks


Visitor wrote:


Hi Misha,

 

VRRP on SRX Chassis Cluster is not supported at all. This is because of the fact that both does the same job. The only difference is that VRRP is stateless  and Chassis cluster provides stateful failover. You can choose either one of them. Refer kb http://kb.juniper.net/InfoCenter/index?page=content&id=KB12881&smlogin=true


Hope this helps.


Regards,

Visitor

-------------------------------------------------------------------------------------------------------

If this post was helpful, please mark this post as an "Accepted Solution".Kudos are always appreciated!