SRX

Hi all,

Recently I deployed sxr210 for dynamic vpn client access. But after a week client now unable to establish vpn connection using junos pulse. Im running junos 11.4r7.5 and junos pulse 2.0. 

I know that to get connected to vpn you need to login twice to verify the credentials but on my situation I've tried to login many times seems I can't establish a connection.

Is there anyone already encounter this? Your response may appreciate.

kind regards,

You could enable logging on the Pulse Client and go from there. Also when you attempt to log in, you could turn on security logging and tracing on the SRX and try to see what is logged as to the reason for the failed connection.

Hi Aren,

      When you say unable to establish VPN connection, do you see any error? is Pulse prompting for authentication?

Try using latest Pulse version 4.0. You can get the latest Pulse version in the below link

http://www.juniper.net/support/downloads/?p=pulse#sw

Thanks,

Hi SHKM,

I don't recieve any error i'ts just always prompting for credential login. But then thanks for response I've already figure out the cause of this. I should not remove my any any policy for dynamic vpn. Although ike phase is successfull and the ipsec phase may not get error but it will not able to process. I dont know now the reason for this so in order my dynamic vpn client work again I've configure again my box to put the any any policy.

best regards,