SRX Services Gateway
SRX Services Gateway

Error during the update SRX4600 cluster

‎01-31-2019 11:53 PM

Hello
I just wanted to update my new srx4600 cluster
if I have the command request system software in-service-upgrade /var/tmp/junos-srxhe-x86-64-18.4R1.8.tgz reboot

I will follow the output

 

ode0:
Chassis ISSU Started
node1:
Chassis ISSU Started
ISSU: Validating Image
ISSU: Pre-check.
ISSU: Pre-check failure. Reason: Priority too low
node0:
JSRPD exited in-service-upgrade window
node1:
JSRPD exited in-service-upgrade window
node0:
Chassis ISSU Aborted
node1:
Chassis ISSU Aborted
ISSU: IDLE
[Feb 1 08:48:54]: ISSU aborted and exiting ISSU window.

 

So the problem comes that the redundancy group 2 both nodes the priorty 0 because the interface is still down?

 

3 REPLIES 3
SRX Services Gateway

Re: Error during the update SRX4600 cluster

‎02-01-2019 12:13 AM

Please share the output of below mentioned commands:

show chassis alarm

show chassis fpc pic-status

show chassis cluster status

show chassis cluster interfaces

show chassis cluster information detail 

 

Thanks,
Nellikka
JNCIE x3 (SEC #321; SP #2839; ENT #790)
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too!!!
SRX Services Gateway
Solution
Accepted by topic author ANFAFFM
‎02-01-2019 12:23 AM

Re: Error during the update SRX4600 cluster

‎02-01-2019 12:17 AM
ISSU won’t work if any node priority is zero as it will stop/prevent automatic failovers
Thanks,
Suraj
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too
Highlighted
SRX Services Gateway

Re: Error during the update SRX4600 cluster

‎06-12-2019 12:31 AM

ANFAFFM, 

Which version are you upgrading from, via ISSU to 18.4R1.8  on 4600  ? . We may have a known software issue around this.