SRX Services Gateway
Highlighted
SRX Services Gateway

IP-IP Tunnel .IPv6 to ipV4 Problem

[ Edited ]
‎12-16-2016 07:01 AM

Hi ,

some hours ago I set up IP-IP Tunnel on my firewall , but tonnel does not working .I can ping address on  my side of the tunnel but i cant ping other side ...

I'm Using Hurricane Electric Free IPv6 Tunnel Broker Service

Firewall Model: Juniper srx240h2

Firmware : 12.3X48-D35.7 
Here is my configuration


interfaces {
  ip-0/0/0 {
    unit 0 {
      tunnel {
        source *.*.*.*;
        destination *.*.*.*;
      }
      family inet6 {
        address *.*.*.*;
      }
    }
  }
}
routing-options {
  rib inet6.0 {
    static {
      route ::/0 next-hop *.*.*.*;
    }
  }
}
security {
  forwarding-options {
    family {
      inet6 {
        mode packet-based;
      }
    }
  }

May be i'm missing something ?

2 REPLIES 2
Highlighted
SRX Services Gateway

Re: IP-IP Tunnel .IPv6 to ipV4 Problem

‎12-16-2016 08:24 PM

Hello,

 

Is there any specific requirement to use only ip-ip tunnel?

Can you try IPSec tunnel or GRE?

 

Regards,

 

Rushi

Highlighted
SRX Services Gateway

Re: IP-IP Tunnel .IPv6 to ipV4 Problem

‎12-17-2016 03:34 AM

Yes it should work. Maybe if you indicate which addresses are configured, that would help, insert some IP addresses so one oculd identify possibly a misconfiguration. The consruct looks ok, but at least indicate what each of the IP represents. Many IP addresses are available that you could substitute

[KUDOS PLEASE! If you think I earned it!
If this solution worked for you please flag my post as an "Accepted Solution" so others can benefit..]