SRX Services Gateway
Highlighted
SRX Services Gateway

New Dynamic VPN Troubleshooting Guide

07.13.10   |  
‎07-13-2010 09:32 PM

 

Need help troubleshooting your Dynamic VPN connection? 

The following has just been published in the Knowledge Base:

[Dynamic VPN] Troubleshoot Dynamic VPN client that is not working (Start here)
http://kb.juniper.net/KB17220
5 REPLIES
SRX Services Gateway

Re: New Dynamic VPN Troubleshooting Guide

01.27.12   |  
‎01-27-2012 07:38 AM

well checking the logs on your SRX is a good start too :-)

SRX Services Gateway

Re: New Dynamic VPN Troubleshooting Guide

05.19.13   |  
‎05-19-2013 11:05 PM

Hello,

 

I have been followed Example: Configuring Dynamic VPN (http://www.juniper.net/techpubs/en_US/junos12.1/topics/example/vpn-security-dynamic-example-configur...)

to configure our dynamic vpn. all moust the same configure with example excetp the IP I changed to ours IP.

But I still can't get it work. I also checked documents on Juniper web site. But not working for me.

I'm not sure how to fix it. Attached is my configurature file . Please help.

 

Thank you.

 

Jason Chen

Attachments

SRX Services Gateway

Re: New Dynamic VPN Troubleshooting Guide

06.18.13   |  
‎06-18-2013 07:57 AM

All I can say is good luck. I have been online with ATAC and JTAC for hours and they are unable to figure the Dynamic tunnel out for us. Funny things that we have SSG's that have no issues with these tunnels yet the Newer SRX's are horrible with VPN's. I bet I have spent more than 90 hours trouble shooting Tunnels with SRX. I so wish we went in another direction then Juniper.

 

SRX Services Gateway

Re: New Dynamic VPN Troubleshooting Guide

09.03.14   |  
‎09-03-2014 01:18 AM

This was my problem too. I tried multiple times but result was same. After that i use web mode and successfully configured it. They i check my command and found almost same but few command was miss match. So, i think you should try with Web mode. After configuring successfully, check your configuring. Hope you will find if you have any mistake there.

SRX Services Gateway

Re: New Dynamic VPN Troubleshooting Guide

04.03.15   |  
‎04-03-2015 02:28 PM

Looking at your config, it looks like you specified the wrong interface for https.  You have

 

set system services web-management https interface vlan.0

 

However, vlan.0 is the protected resource side.

 

Try adding ge-0/0/0.0 to the https interface, then try again.