SRX Services Gateway
Highlighted
Alecsuhuynh
SRX Services Gateway

Re: Community FAQ - 2018 Update

‎12-04-2018 11:31 PM

Hi every boday

I have a Juniper device SRX240H2 , and with the detail info as below.

Software Version:   JUNOS Software Release [11.4R11.4]
Bios Version:   2.4

Now, I would like to monitor it by Manage Engine NetFlow Analyzer (version 9.6). Can anyone help me to check is it OK? Do I need to upgrade NetFlow software version or Juniper firmware??

 

Please help to advise

2 REPLIES 2
Highlighted
SRX Services Gateway

Re: Community FAQ - 2018 Update

‎12-18-2018 02:22 PM

Hi Alecsuhuynh -

 

I wanted to get your question a bit more visibility by moving it to the SRX forum (All - I apologize if this isn't the correct forum to move it to, please let me know if it should be elsewhere)

 

Hope this helps!

Jeremiah, J-Net Community Manager

Jeremiah
J-Net Community Manager
Highlighted
SRX Services Gateway

Re: Community FAQ - 2018 Update

‎12-18-2018 04:03 PM

You can configure netflow on the SRX following these instructions.

 

https://kb.juniper.net/InfoCenter/index?page=content&id=KB16677

 

Your current version of Junos does support this.  But it is an EOL version and you should consider upgrading the 12.3 version if you have support for access to downloads.

 

Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home
Feedback