Does the HA control link for SRX 1500 have to be fiber? I am staging a pair with copper SFPs and looks like both nodes are sending heartbeats but not receiving:
root> show interfaces em0 extensive
Physical interface: em0 , Enabled, Physical link is Up
Interface index: 8, SNMP ifIndex: 17, Generation: 1
Type: Ethernet, Link-level type: Ethernet, MTU: 1514, Clocking: Unspecified,
Speed: 1000mbps
Device flags : Present Running
Interface flags: SNMP-Traps
Link type : Full-Duplex
Physical info : Unspecified
Hold-times : Up 0 ms, Down 0 ms
Current address: 02:00:00:01:01:04, Hardware address: 02:00:00:01:01:04
Alternate link address: Unspecified
Last flapped : Never
Statistics last cleared: Never
Traffic statistics:
Input bytes : 0
Output bytes : 0
Input packets: 67167
Output packets: 75284
Input errors:
Errors: 0, Drops: 0, Framing errors: 0, Runts: 0, Giants: 0,
Policed discards: 0, Resource errors: 0
Output errors:
Carrier transitions: 0, Errors: 0, Drops: 0, MTU errors: 0,
Resource errors: 0
root> show chassis cluster statistics
Control link statistics:
Control link 0:
Heartbeat packets sent: 3288
Heartbeat packets received: 0
Heartbeat packet errors: 0
Fabric link statistics:
Child link 0
Probes sent: 0
Probes received: 0
Child link 1
Probes sent: 0
Probes received: 0
root> show chassis cluster interfaces
Control link status: Down
Control interfaces:
Index Interface Monitored-Status Internal-SA
0 em0 Down Disabled
Fabric link status: Down
Fabric interfaces:
Name Child-interface Status
(Physical/Monitored)
fab0
fab0
Redundant-pseudo-interface Information:
Name Status Redundancy-group
lo0 Up 0
{primary:node0}
root> show chassis cluster information
node0:
--------------------------------------------------------------------------
Redundancy Group Information:
Redundancy Group 0 , Current State: primary, Weight: 255
Time From To Reason
Jul 8 20:56:30 hold secondary Hold timer expired
Jul 8 20:56:46 secondary primary Only node present
Chassis cluster LED information:
Current LED color: Red
Last LED change reason: Peer node: node1 is not present
Failure Information:
Control-link Failure Information:
Link Status: Monitor Failed
Dual Control Link Status: Unsupported
Interface Physical / Monitored Status
em0 Up / Down