SRX Services Gateway
SRX Services Gateway

SRX 340 tranparent mode cluster SNMP configuration

‎04-11-2019 03:22 AM

Hi,

I got the some technical error.i would like to configuration SNMP configuration in my SRX cluster.

I am using L2 tranparent mode chassis cluster.So i don't know which interface should i use for SNMP source ? Should i use loopback interface or reth interface ?

Pleae help link or sample .

2 REPLIES 2
SRX Services Gateway

Re: SRX 340 tranparent mode cluster SNMP configuration

‎04-11-2019 03:45 AM

Hi aungzawtun,

 

"irb" interface can be used as source.

 

Sample management config in a transparent mode:-

set groups node0 interfaces fxp0 unit 0 family bridge interface-mode access vlan-id 20
set groups node1 interfaces fxp0 unit 0 family bridge interface-mode access vlan-id 20
set groups node0 interfaces irb unit 0 family inet address 192.168.1.1/24


set groups node1 interfaces irb unit 0 family inet address 192.168.1.2/24


set bridge-domains mgmt domain-type bridge vlan-id 20 routing-interface irb.0


set routing-options static route 0.0.0.0/0 next-hop 192.168.1.254

 

Regards,

 

Rahul

Regards,
Rahul
SRX Services Gateway
Solution
Accepted by topic author aungzawtun
‎05-14-2019 07:40 PM

Re: SRX 340 tranparent mode cluster SNMP configuration

‎04-11-2019 12:16 PM

Hello, aungzawtun

 

Because the SRX340 have fxp0 interfaces for OoB management, you can use these interfaces for SNMP monitoring; I have seen this working before. Here I attached a config example:

 

https://kb.juniper.net/InfoCenter/index?page=content&id=KB16545

 

In transparent mode also you have the IRB for regular management, so I assume that you can also use this interface.

 

Please let us know if you have further questions.

 

Pura Vida from Costa Rica - Mark as Resolved if it applies.
Kudos are appreciated too!