Hi,
We're in the process of setting up a cluster with two SRX240s and having some issues around vlan trunking within the reth interfaces. The cluster has four switches coming off it, one core switch and three access switches.
We currently use LAGs on node0 until we get the reth interfaces working, configuration is like below on LAGs:
> show configuration interfaces ae0
aggregated-ether-options {
lacp {
active;
}
}
unit 0 {
family ethernet-switching {
port-mode trunk;
vlan {
members [ servers staff voice ];
}
}
}
The problem happens when I try to set this up as a reth interface:
> show configuration interfaces reth0
redundant-ether-options {
redundancy-group 1;
lacp {
active;
}
}
unit 0 {
family ethernet-switching {
port-mode trunk;
vlan {
members [ servers staff voice ];
}
}
}
It comes up with an error when doing a commit that family ethernet-switching isn't supported. I then tried the below but am unable to ping anyting over the link:
> show configuration interfaces reth0
redundant-ether-options {
redundancy-group 1;
lacp {
active;
}
}
vlan-tagging;
unit 5 {
vlan-id 5;
}
unit 6 {
vlan-id 6;
}
unit 99 {
vlan-id 99;
}
I have also tried bridging but this fails as we use IPsec tunnels off the router, as well as DynamicVPN:
> show configuration interfaces reth0
redundant-ether-options {
redundancy-group 1;
lacp {
active;
}
}
vlan-tagging;
unit 5 {
family bridge {
interface-mode trunk;
vlan-id 5;
}
unit 6 {
family bridge {
interface-mode trunk;
vlan-id 6;
}
unit 99 {
family bridge {
interface-mode trunk;
vlan-id 99;
}
Does anyone have any other suggestions that I can try, I can't assign IP addresses to the logical interface vlans as we need the vlan accessible on other switches also.
We're currently on Junos 12.1R7.9.
Cheers,
Glenn