SRX Services Gateway
SRX Services Gateway

SRX240H2 Multiple traffic-selectors on IKEV2

‎01-14-2019 09:44 PM

Hi there,

 

I need to establish a IPSec connection between a static and a dynamic IP endpoint. The SRX240H2 has the static IP. I planed to use IKEv2 but then I found out that the software Version 12.3X48-D60.2 installed on the device does not support multiple traffic-selectors in IKEv2. This feature was added in 15.1X49-D100. Is there a Chance that this feature will come to this hardware?

 

Thanks in advance

Clemens

2 REPLIES 2
SRX Services Gateway

Re: SRX240H2 Multiple traffic-selectors on IKEV2

‎01-14-2019 11:04 PM

The SRX240 will never run anything newer than the 12.3X48 software train. To get 15.1X49-D100 or newer you will need a SRX300 series, SRX550HM or SRX1500 device.


--
Best regards,

Jonas Hauge Klingenberg
Systems Engineer, SEC DATACOM A/S (Denmark)
SRX Services Gateway

Re: SRX240H2 Multiple traffic-selectors on IKEV2

‎01-14-2019 11:28 PM

Hi, Proventa

 

As you can see the SRX240 was already annouce End-of-life so I wouldnt expect the feature to be added:

 

https://support.juniper.net/support/eol/hardware/srx_series/ 

 

Still you could achieve your goal using IKEv1.

 

I hope the above info helps.

 

Pura Vida from Costa Rica - Mark as Resolved if it applies.
Kudos are appreciated too!