Hi ,
Not sure if my suggestions will help.
Following commands will show the details:
root@Site-A> show configuration | display set | match address-set
set security zones security-zone Trust address-book address-set Local-Set address Local-Network
set security zones security-zone Trust address-book address-set Local-Set address Local-Network1
set security zones security-zone Trust address-book address-set Local-Set address Local-Network2
++++++++++++++++++
root@Site-A> show security policies policy-name test-policy detail
Policy: test-policy, action-type: permit, State: enabled, Index: 6, Scope Policy: 0
Policy Type: Configured
Sequence number: 1
From zone: Trust, To zone: Untrust
Source addresses:
Local-Network2: 192.168.112.0/24
Local-Network1: 192.168.111.0/24
Local-Network: 192.168.100.0/24
Destination addresses:
any-ipv4(global): 0.0.0.0/0
any-ipv6(global): ::/0
Application: any
IP protocol: 0, ALG: 0, Inactivity timeout: 0
Source port range: [0-0]
Destination port range: [0-0]
Per policy TCP Options: SYN check: No, SEQ check: No
Regards,
rparthi
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated Too