enaling ssh service on loopback interface in srx1500
i want to configure ssh service on my loopback interface in srx1500.i put this interface in trust zone and enabled services all and protocols all on this zones.and beside that i enabled services all and protocols all on this intrface as well.but whenever i access it through ssh , the putty doesnt respond me .any idea about it....pls share
Re: enaling ssh service on loopback interface in srx1500
Is the loopback address reachable on the network you are connecting from?
When you ping and trace route to the loopback address does it respond to ping and go the expected direction.
For self traffic you don't normally need a security policy but if you do setup policies for self traffic you would use the junos-host zone as the to-zone to establish the restrictions. Without a junos-host policy the services / protocols enable on the zone host inbound services are simply allowed from everywhere.
Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP) http://puluka.com/home