> Hi,
>
> do you change this variable on your srx ?
>
> kenv boot.upgrade.uboot=0xbf400000
> kenv boot.upgrade.loader=0xbf600000
>
> after i change this variable and restart the box, my srx unable to boot up.
> Regards,
> ND
When you say your SRX does not boot up, what does it mean?
- It does not show any thing on console after hard power cycle?
- It stops at bootloader?
Merely kenv commands do not change persistent state of the system. So, even if you execute the kenv commands above and hard power cycle, the system should boot up.
Is there any thing else you tried before or after these commands. That might give a clue as to what went wrong with the system.
Regards