Is it possible to make the SRX to behave when redundancy group 1 is failover from node0 to node1, the redundancy group 0 will also follow failover to node0 to node1 ?
Redundancy group: 0 , Failover count: 2node0 129 primary no no Nonenode1 128 secondary no no None
Redundancy group: 1 , Failover count: 2node0 100 primary no no Nonenode1 2 secondary no no None
MANUAL FAIL OVER
request chassis cluster failover redundancy-group 1 node 1
Redundancy group: 0 , Failover count: 2 --> how to make the state as Redundancy group 1 ?node0 129 primary no no Nonenode1 128 secondary no no None
Redundancy group: 1 , Failover count: 3node0 100 secondary no yes Nonenode1 255 primary no yes None
Thanks in advance
Do you mean fail both when you issue the manual cli command? If you monitor the same interfaces then both rg's will failover when the weight reachs 0.
You can achieve this by configuring interface-monitor for teh same interfaces which are being monitored on the RG1 or other RGs.
However, this is not recommended and also this will work only when the interface being monitored goes down.
The failover done manually would not cause the simultaneous failover.
For that you will have to run some script created for this.