SRX

I am in the process of setting up my first Juniper device, a SRX 100H2 and the Dynamic VPN is giving me some problems. I just need a very basic IPSec vpn so I followed the wizard, but when I navigate to https://PublicAddress/dynamic-vpn I am getting a 404.

My configuration is rather simple, I have fe 0/0 configured to face the internet zone and it has two IP blocks associated with it. A /30 block for basic internal web traffic and a seperate /29 block which is used to host a couple web and mail servers. The /29 block has a few IP addresses Setup with Static NAT, but it also has 2 unused addresses. I have tried accessing /dynamic-vpn from using IP addresses in both blocks but I still haven’t had any luck.

I have tried looking though the SRX Getting Started - Configure Dynamic VPN (VPN Client) and the dynamic-vpn-appnote-junos10.4-v21.pdf but I am not having much luck. 

Thanks for the help

Have you enabled https in the host-inbound services on the fe-0 inteface in the external zone? You may need to show our configuration (cli output) . You cn replace all your personal IP network with something else before posting.

The wizard usually assigns the ip address of the fe-0/0/0 interface primary address by default.

the wizard should have made the necessary changes to your host inbound services.

Did you make any other changes after running the wizard?

It appears I am an idiot, and you can't check https://x.x.x.x/dynamic-vpn from behind the srx. So that solves that problem, on to IKE negotation failed (error: 1419)!