SRX Services Gateway
SRX Services Gateway

remove old routing entry in inet.0

‎02-07-2014 08:38 PM

Hi all

 

I have a couple of SRX240s with a VPN between them. The VPN is up at both ends but there appears to be a routing issue inbetween them. When I look at the routing table INET.0 there is a route in there for 192.168.20.0/24 with next hop of st0.0 whereas it should be st0.6. My question is how do I get INET.0 updated to point to st0.6 instead of st0.0?

2 REPLIES 2
SRX Services Gateway
Solution
Accepted by topic author david@asl.com.au
‎08-26-2015 01:27 AM

Re: remove old routing entry in inet.0

‎02-08-2014 04:46 AM

You would enter configuration mode and delete the route to st0.0 and set a new route to st0.6.  Then commit the changes.

Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home
SRX Services Gateway

Re: remove old routing entry in inet.0

‎02-08-2014 03:30 PM

Thanks 

 

After editing the routing on both sides through the CLI traffic is now correctly routing across the VPN.