Hello, everybody,have the following problem:Restarted the cluster after a software update.After restart em1 was up. Then the other interfaces came up and em1 go down.I already did an ifconfig em1 up on the shell but without success.
Had a similar problem on a SRX3600. Here the following method helped:
Is there a similar command on the srx4600?
What else can I do to get em1 up?
Control interfaces: Index Interface Monitored-Status Internal-SA Security0 em0 Up Disabled Disabled 1 em1 Down Disabled Disabled
srx4600 has two dedicated control ports. Did you connect both ports between the nodes? Is it directly connected or is thery any switch in between? Was em1 up before upgrade?
Please share the output of below mentioned commands:
show chassis pic fpc-slot 0 pic-slot 0 node 0
show chassis pic fpc-slot 0 pic-slot 0 node 1
show interfaces terse xe-/*
Yes it directly connected
© 1999 - 2019 Juniper Networks, Inc.
All rights reserved