SRX Services Gateway
Highlighted
SRX Services Gateway

web-management port

[ Edited ]
‎06-06-2017 07:04 AM

Hi there,

 

My web management is being accessed  from ge-0/0/0 and I need it to be accessed also by ge-1/0/0

I need both allowed. which command I shoould run to add the ge-1/0/0 to the config below?

 

 services {
        ssh;
        telnet;
        xnm-clear-text;
        web-management {
            management-url admin;
            http {
                port 8081;
                interface [ vlan.0 ge-0/0/0.0 ];
            }
            https {
                system-generated-certificate;
            }
        }

Kind regards.

3 REPLIES 3
Highlighted
SRX Services Gateway
Solution
Accepted by topic author rdgcatell
‎06-07-2017 01:41 PM

Re: web-management port

‎06-06-2017 03:51 PM

To add the port your use:

 

set system services web-management http interface ge-1/0/0.0

You will also need to confirm that the zone which this port is assigned allows the connection as well.

set security zones security-zone NameOfZone host-inbound-traffic system-services http

or

set security zones security-zone NameOfZone host-inbound-traffic system-services all
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home
Highlighted
SRX Services Gateway

Re: web-management port

‎06-07-2017 01:41 PM

Worked. Thanks...

 

Now my last question:

 

My web-management-url  is set "admin".. how do I use this?

 

my internal IP is 10.196.24.1, so if I put 10.196.24.1/admin is should open the web management?

if yes its not working.

 

I am using the 8081 port.

 

Kind regards.

Highlighted
SRX Services Gateway

Re: web-management port

‎06-07-2017 01:57 PM

Yes, the custom url comes after the ip address.  But in your case you also have a custom port which would be added.

 

10.196.24.1:8081/admin
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/home
Feedback