Screen OS

last person joined: 8 months ago 

This is a legacy community with limited Juniper monitoring.

  • 1.  How to transfer traffic to the Router?

    Posted 05-19-2016 23:03

    Hello all,

    I want to transfer traffic to the Router like below captured picture.

     

    All of 192.168.240.0/24 network which is come SSG-5 should go to the Router.

     

    The step that I configure is just "set route 192.168.240.0/24 gateway 10.152.4.25" ??

     

     

     

    Network design.jpeg

     

    Regards,

    SK.



  • 2.  RE: How to transfer traffic to the Router?

    Posted 05-19-2016 23:20

    1:set route 192.168.240.0/24 gateway 10.152.4.25. This will forward traffic to 10.152.4.25 which is destined to 192.168.240.0/24.

     

    2: however,  192.168.240.0/24 will be your source addresses not the destination addresses, right? 

     

    3: the command should be "set route  <destination IPv4 Address/Netmask>  gateway 10.152.4.25" , use 0.0.0.0/0 as destination address if you want everything to go to the 10.152.4.25.

     

    check KB http://kb.juniper.net/InfoCenter/index?page=content&id=KB5712&actp=search , you can add interface also in the static routes. 

     

    Thanks,

    Vikas



  • 3.  RE: How to transfer traffic to the Router?

    Posted 05-19-2016 23:36

    Ah!! Sorry to confusing you.

     

    The IP 192.168.240.0/24 is destination IP not PCs!!

     

    Could you reply again..?



  • 4.  RE: How to transfer traffic to the Router?
    Best Answer

    Posted 05-19-2016 23:50

    Ok, if 192.168.240.0/24 is the destination then "set route 192.168.240.0/24 gateway 10.152.4.25" will send the packets to the 10.152.4.25 .

     

    Thanks,

    Vikas



  • 5.  RE: How to transfer traffic to the Router?

    Posted 05-20-2016 00:00

    It's simple!! ^^

    Thank you so much!