ScreenOS Firewalls (NOT SRX)
Highlighted
ScreenOS Firewalls (NOT SRX)

no source ip address for interface ethernet

06.18.08   |  
‎06-18-2008 08:44 PM

There was a error messages When I use ping to check host at trust zone in Vsys.

 

no source ip address for interface ethernet3/1.62:1

 

 

5 REPLIES
ScreenOS Firewalls (NOT SRX)

Re: no source ip address for interface ethernet

06.19.08   |  
‎06-19-2008 09:48 PM

Can you give us the syntax of the entire ping command you entered?

Can you show us the output of 'get int eth3/1.62:1'?

Can you show us the output of 'get route ip x.x.x.x', where x.x.x.x is the IP you were pinging?

Those should give us some clues.

Josine 

 

ScreenOS Firewalls (NOT SRX)

Re: no source ip address for interface ethernet

[ Edited ]
04.04.12   |  
‎04-04-2012 01:24 PM

I get this error if I attempt to ping from my backup cluster device.  It works fine if I ping from the master node instead.

ScreenOS Firewalls (NOT SRX)

Re: no source ip address for interface ethernet

04.05.12   |  
‎04-05-2012 06:05 AM
A backup device has (some of) its interfaces down or inactive. In your case, probably all of them (by all I mean those that could be used to get source ip for the ping). For further troubleshooting, see previous post.
ScreenOS Firewalls (NOT SRX)

Re: no source ip address for interface ethernet

06.22.13   |  
‎06-22-2013 03:06 PM

Hi, Cameron

 

have you solved your problem about "no source ip address for interface ethernet" error on your backup cluster device?

because I have the same problem.

ScreenOS Firewalls (NOT SRX)

Re: no source ip address for interface ethernet

06.24.13   |  
‎06-24-2013 05:09 AM

Hello,

 

On the backup firewall, i see this error if the interface does not have a manage-ip configured.

 

if my eth0/1 has ip address 1.1.1.1/24, then.

 

on master firewall, set interface eth0/1 manage-ip 1.1.1.2

on backup firewall, set interface eth0/1 manage-ip 1.1.1.3

 

This is the behavior i see from some quick tests on 6.3.0r12.

 

Regards,

Sam